Represents interface data.
| Field | Type | Description |
|---|---|---|
| admin_is_up | uint32 | Admin state |
| mtu | uint32 | Maximum transmission unit |
| if_type | IfMgrIfType | Interface type; for example, loopback, physical, or LAG |
| port_id | PortIdPb | Port identifier |
| description | string | Interface description |
| mac_addr | MacAddressPb | MAC address |
| aggregate_id | string | associated aggregate id |
| oper_is_up | uint32 | Operational state |
Represents interface key.
| Field | Type | Description |
|---|---|---|
| if_name | string | Interface name; for example, ethernet 1/1 |
Represents interface notification.
| Field | Type | Description |
|---|---|---|
| op | SdkMgrOperation | Operation such as create, delete, or update |
| key | InterfaceKey | Interface key |
| data | InterfaceData | Interface data |
Represents interface subscription request.
| Field | Type | Description |
|---|---|---|
| key | InterfaceKey | Optional, to filter on name |
Empty message from agent.
| Field | Type | Description |
|---|---|---|
| es_id | bytes | Type 0 for now. hard-coded id |
Represents global interface identifier.
| Field | Type | Description |
|---|---|---|
| global_if_id | uint32 | Global interface identifier |
Represents IP prefix.
| Field | Type | Description |
|---|---|---|
| ip_addr | IpAddressPb | IP address |
| prefix_length | uint32 | IP address prefix length |
Represents IP address.
| Field | Type | Description |
|---|---|---|
| addr | bytes | IP address |
Represents IP prefix state.
| Field | Type | Description |
|---|---|---|
| prefix | IpAddrPrefLenPb | IP prefix |
| state | IpAddressState | IP prefix state |
Represents MAC address.
| Field | Type | Description |
|---|---|---|
| mac_address | bytes | MAC address |
Represents MPLS label.
| Field | Type | Description |
|---|---|---|
| mpls_label | uint32 | MPLS label |
Represents network instance identifier.
| Field | Type | Description |
|---|---|---|
| instance_id | uint32 | Network instance identifier |
Represents port identifier.
| Field | Type | Description |
|---|---|---|
| port_id | uint64 | Port identifier |
Empty message for synchronization request.
Empty message for synchronization end.
| Field | Type | Description |
|---|---|---|
| status | SdkMgrStatus | Error code |
| error_str | string | Detailed error string |
Represents interface ethernet duplex mode. Corresponds to yang values
| Name | Number | Description |
|---|---|---|
| IF_ETH_DUPLEX_MODE_UNSET | 0 | duplex mode not supported |
| IF_ETH_DUPLEX_MODE_FULL | 1 | |
| IF_ETH_DUPLEX_MODE_HALF | 2 |
Represents interface ethernet port speed. Corresponds to yang values
| Name | Number | Description |
|---|---|---|
| IF_ETH_PORT_SPEED_UNSET | 0 | Speed unknown |
| IF_ETH_PORT_SPEED_10M | 1 | |
| IF_ETH_PORT_SPEED_100M | 2 | |
| IF_ETH_PORT_SPEED_1G | 3 | |
| IF_ETH_PORT_SPEED_10G | 4 | |
| IF_ETH_PORT_SPEED_25G | 5 | |
| IF_ETH_PORT_SPEED_40G | 6 | |
| IF_ETH_PORT_SPEED_50G | 7 | |
| IF_ETH_PORT_SPEED_100G | 8 | |
| IF_ETH_PORT_SPEED_200G | 9 | |
| IF_ETH_PORT_SPEED_400G | 10 | |
| IF_ETH_PORT_SPEED_1T | 11 | |
| IF_ETH_PORT_SPEED_800G | 12 |
Represents interface loopback mode. Corresponds to yang values
| Name | Number | Description |
|---|---|---|
| IF_LOOPBACK_MODE_UNSET | 0 | loopback mode not supported |
| IF_LOOPBACK_MODE_NONE | 1 | |
| IF_LOOPBACK_MODE_FACILITY | 2 | |
| IF_LOOPBACK_MODE_TERMINAL | 3 |
Represents interface type.
| Name | Number | Description |
|---|---|---|
| ETHERNET | 0 | Ethernet interface |
| LOOPBACK | 1 | Loopback interface |
| MANAGEMENT | 2 | Management interface |
| AGGREGATE | 3 | Aggregate(LAG) interface |
| IRB | 4 | Integrated Routing and Bridging (IRB) interface |
| SYSTEM | 5 | System interface |
| LIF | 6 | linux interface |
| NIC | 7 | linux nic interface (bus/dev/fn) |
| VHOST | 8 | vhost-net interface, vhn-<name> name for sock-path |
| KKLIF | 9 | temp name for new style of lif interface |
| KKVHOST | 10 | temp name for new style of vhost interface |
| SYNC | 11 | 1588 sync interface |
| IF_TYPE_MAX | 12 |
| Name | Number | Description |
|---|---|---|
| IF_OPER_DOWN_NONE | 0 | |
| IF_OPER_DOWN_PORT_ADMIN_DISABLED | 1 | |
| IF_OPER_DOWN_MDA_ADMIN_DISABLED | 2 | |
| IF_OPER_DOWN_TRANS_LASER_DISABLED | 3 | |
| IF_OPER_DOWN_MDA_NOT_PRESENT | 4 | |
| IF_OPER_DOWN_TRANS_NOT_PRESENT | 5 | |
| IF_OPER_DOWN_PHY_INIT | 6 | |
| IF_OPER_DOWN_LOWER_LAYER_DOWN | 7 | |
| IF_OPER_DOWN_MTU_RESOURCES | 8 | |
| IF_OPER_DOWN_UNSUPPORTED_SPEED | 9 | |
| IF_OPER_DOWN_UNSUPPORTED_TRANS_FEC | 10 | |
| IF_OPER_DOWN_OTHER | 11 | |
| IF_OPER_DOWN_PORT_NOT_PRESENT | 12 | used internally by chassis mgr only - xdp never publish to IDB! |
| IF_OPER_DOWN_FABRIC_AVAILABILITY | 13 | used internally by chassis mgr only - xdp never publish to IDB! |
| IF_OPER_DOWN_NO_ACTIVE_LINKS | 14 | lag interface only |
| IF_OPER_DOWN_MIN_LINK_THRESHOLD | 15 | lag interface only |
| IF_OPER_DOWN_9_12_SPEED_MISMATCH | 16 | Vodka port 9-12 must all be same speed as port 9 |
| IF_OPER_DOWN_LAG_RESOURCES | 17 | lag interface only |
| IF_OPER_DOWN_LAG_MEMBER_RESOURCES | 18 | lag member interface only |
| IF_OPER_DOWN_STANDBY_SIGNALING | 19 | ESM multihoming |
| IF_OPER_DOWN_HOLD_TIME_UP_ACTIVE | 20 | interface hold-time up is actively holding the interface down |
| IF_OPER_DOWN_RELOAD_TIME_ACTIVE | 21 | interface reload time is actively holding the interface down |
| IF_OPER_DOWN_CONNECTOR_DOWN | 22 | parent connector oper down forces breakout port oper down |
| IF_OPER_DOWN_AUTO_NEG_MISMATCH | 23 | |
| IF_OPER_DOWN_EVENT_HANDLER | 24 | used internally by chassis mgr only - xdp never publish to IDB! |
| IF_OPER_DOWN_UNSUPPORTED_BREAKOUT | 25 | interface doesn't support breakout config |
| IF_OPER_DOWN_CFM_CCM_DEFECT | 26 | |
| IF_OPER_DOWN_CRC_MON_FAIL_THRESH | 27 | crc-monitor signal failure threshold exceeded |
| IF_OPER_DOWN_SYMBOL_MON_FAIL_THRESH | 28 | symbol-monitor signal failure threshold exceeded |
Represents interface operational state.
| Name | Number | Description |
|---|---|---|
| IF_OPER_STATE_UP | 0 | Interface operational state up |
| IF_OPER_STATE_DOWN | 1 | Interface operational state down |
| IF_OPER_STATE_TESTING | 2 | Interface operational state testing |
| IF_OPER_STATE_UNKNOWN | 3 | Interface operational state unknown |
| IF_OPER_STATE_DORMANT | 4 | Interface operational state dormant |
| IF_OPER_STATE_NOT_PRESENT | 5 | Interface operational state not present |
| IF_OPER_STATE_LOWER_LAYER_DOWN | 6 | Interface operational state lower layer down |
Represents interface transceiver fec. Corresponds to yang values
| Name | Number | Description |
|---|---|---|
| IF_TRANS_FEC_UNSET | 0 | Fec unknown |
| IF_TRANS_FEC_DISABLED | 1 | |
| IF_TRANS_FEC_RS528 | 2 | |
| IF_TRANS_FEC_RS544 | 3 | |
| IF_TRANS_FEC_BASER | 4 | |
| IF_TRANS_FEC_RS108 | 5 |
Represents IP address state.
| Name | Number | Description |
|---|---|---|
| IPADDR_STATE_UNKNOWN | 0 | IP address state unknown |
| IPADDR_STATE_TENTATIVE | 1 | IP address state tentative |
| IPADDR_STATE_DUPLICATED | 2 | IP address state duplicated |
| IPADDR_STATE_INACCESSIBLE | 3 | IP address state inaccessible |
| IPADDR_STATE_DEPRECATED | 4 | IP address state deprecated |
| IPADDR_STATE_PREFERRED | 5 | IP address state preferred |
Represents enumeration value for operation in subscription.
| Name | Number | Description |
|---|---|---|
| Create | 0 | Create operation |
| Update | 1 | Update operation |
| Delete | 2 | Delete operation |
Represents status of network programming service calls.
| Name | Number | Description |
|---|---|---|
| kSdkMgrSuccess | 0 | Successful service call |
| kSdkMgrFailed | 1 | Failed service call |
| Proto Type | Notes | C++ | Java | Python | Go | C# | PHP | Ruby |
|---|---|---|---|---|---|---|---|---|
| double | double | double | float | float64 | double | float | Float | |
| float | float | float | float | float32 | float | float | Float | |
| int32 | Uses variable-length encoding. Inefficient for encoding negative numbers – if your field is likely to have negative values, use sint32 instead. | int32 | int | int | int32 | int | integer | Bignum or Fixnum (as required) |
| int64 | Uses variable-length encoding. Inefficient for encoding negative numbers – if your field is likely to have negative values, use sint64 instead. | int64 | long | int/long | int64 | long | integer/string | Bignum |
| uint32 | Uses variable-length encoding. | uint32 | int | int/long | uint32 | uint | integer | Bignum or Fixnum (as required) |
| uint64 | Uses variable-length encoding. | uint64 | long | int/long | uint64 | ulong | integer/string | Bignum or Fixnum (as required) |
| sint32 | Uses variable-length encoding. Signed int value. These more efficiently encode negative numbers than regular int32s. | int32 | int | int | int32 | int | integer | Bignum or Fixnum (as required) |
| sint64 | Uses variable-length encoding. Signed int value. These more efficiently encode negative numbers than regular int64s. | int64 | long | int/long | int64 | long | integer/string | Bignum |
| fixed32 | Always four bytes. More efficient than uint32 if values are often greater than 2^28. | uint32 | int | int | uint32 | uint | integer | Bignum or Fixnum (as required) |
| fixed64 | Always eight bytes. More efficient than uint64 if values are often greater than 2^56. | uint64 | long | int/long | uint64 | ulong | integer/string | Bignum |
| sfixed32 | Always four bytes. | int32 | int | int | int32 | int | integer | Bignum or Fixnum (as required) |
| sfixed64 | Always eight bytes. | int64 | long | int/long | int64 | long | integer/string | Bignum |
| bool | bool | boolean | boolean | bool | bool | boolean | TrueClass/FalseClass | |
| string | A string must always contain UTF-8 encoded or 7-bit ASCII text. | string | String | str/unicode | string | string | string | String (UTF-8) |
| bytes | May contain any arbitrary sequence of bytes. | string | ByteString | str | []byte | ByteString | string | String (ASCII-8BIT) |
Created by Siva Sivakumar / Roman Dodin / srl-labs